Now this great little tool is an absolute must!!!…. for anyone taking on the challenge of clutch replacement on a Subaru. Unless the clutch drive plate is perfectly aligned to the flywheel you’re going to struggle to relocate the gearbox onto the back of the engine after clutch replacement. This inexpensive, simple yet effective tool is made from plastic and removes this alignment headache. The small narrow end locates into the spiggot bearing on the flywheel. The 1inch/24 spline locates on the drive plate. On the end is a pull ring for removing once the clutch pressure plate has been tightened down. If your buying a clutch, make sure you pop one of these in your basket!
